![]() ![]() This is where your 90-degree PVC elbow pieces come in.įirst, attach one elbow to the end of your long pipe, followed by a short piece of PVC pipe and an adapter. On the other end of the pipe, however, you’re going to add a slip coupling to screw a threaded cap later on. Popping an endcap on one side of the pipe length is a good idea to protect your cover reel from filling up with water or becoming a lair for unwanted pests. Grab one of your PVC pipe endcaps and install it on one end of the length of the pipe. Step 3: Add an Endcap & Make Your Hand Crank In this case, you can easily use some PVC primer and glue to attach the two sections together. If you have a large pool and therefore a large pool cover, maybe you opted to buy two segments of PVC pipe rather than one longer one for ease of transport. Step 2.5: Glue PVC Sections Together (Optional) If you’re a DIY guru or home improvement master, you’ll probably have most of these tools on-hand but if not, they can be found at most hardware stores. Schedule 40 PVC pipe is sturdy, inexpensive, water-safe, and is easy to work with. We recommend using Schedule 40 PVC pipe with a 1-inch diameter for this project. These are all very common and inexpensive materials that shouldn’t cost you more than a couple of bucks each. Once you’ve determined the correct length of PVC pipe you’ll need, you can go shopping for the required items you’ll need. Measure the width of the cover to determine how long of a PVC pipe you’ll need for your cover reel. Take your tarp or pool cover to a wide-open space and lay it out flat. Step 5: Drill Screw Holes in the Clips and Pipe.Step 4.5: Paint the Clips and Pipe (Optional).Step 4: Make Clips to Attach the PCV Pipe to the Cover.Step 3: Add an Endcap & Make Your Hand Crank.Step 2.5: Glue PVC Sections Together (Optional). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |